Latest Exam Prep

QUESTION 36
Antifouling coatings are regulated by international treaties.

QUESTION 37
It is always possible to see moisture on a steel substrate:

QUESTION 38
Application of Thermal Spray Coatings requires:

QUESTION 39
You are working as an inspector in a galvanizing plant for the first time.
What are some of the hazards you need to be aware of:

QUESTION 40
Non-Conformance Reports are designed to:

QUESTION 41
From a corrosion perspective, the main difference between Ferrous and Non-Ferrous Metals is:

QUESTION 42
NACE No.13/ SSPC 6 identifies the use of:

QUESTION 43
Galvanizing performs best in which of the following exposures:

QUESTION 44
The primary purpose of Fireproofing coatings are to provide:

QUESTION 45
In which type of concrete are laitance commonly encountered?

QUESTION 46
The main reason dehumidification is used during coating operations is to

QUESTION 47
NACE/SSPC Water Jetting standards are directly equivalent to ISO Abrasive Blast Standards:

QUESTION 48
As a NACE Level 2 Inspector on a field job; prior to submission your documentation should always reviewed and approved by:

QUESTION 49
Because a NACE Level 2 Inspector has been trained in specific destructive tests, it is up to the Inspector to decide if and when a destructive test is required.

QUESTION 50
Dehumidification is defined as the removal of moisture vapor from the air to

QUESTION 51
The solvent sensitivity/solvent wipe test (ASTM D4752) is used to determine the cure of

QUESTION 52
When ASIN D 3363 is specified the Inspector must:

QUESTION 53
All of these are advantages of using repair patches EXCEPT

QUESTION 54
Differences in technique for abrasive blasting concrete versus steel require the operator to:

QUESTION 55
You are the NACY Coating Inspector on a tank lining project where desiccant dehumidification is being used. Since the first shift of abrasive blasting your readings have indicated relative humidity below 40%; however on the second shift of coating application your readings are indicting 80%.
Your FIRST preferred course of action is to:

QUESTION 56
Ideally, documentation requirements should be defined: