QUESTION 22
What is the maximum amount of Appliances within the same Security Group?

QUESTION 23
What cannot be learned from the output of asg monitor command?

QUESTION 24
What is the default IP range of CIN network (with no increment)?

QUESTION 25
Orchestrator should be defined in SmartConsole as:

QUESTION 26
What is the purpose of Management ports located on the Rear Panel of the Orchestrator MHO-140?

QUESTION 27
What cannot be learned from the output of lldpctl?

QUESTION 28
What does the lldpctl command do?

QUESTION 29
What will happen in case of NAT of the traffic passing through Management network?

QUESTION 30
In order to set Site (chassis) priority per VS, following command should be used:

QUESTION 31
There are two appliances within the same Security Group. One of them is connected by One downlink only, another one by Two downlinks. Assuming there’s no NAT and no VPN, what would be proportion of traffic distribution done by Orchestrator?

QUESTION 32
What is the max amount of Orchestrators in Dual-site setup?

QUESTION 33
What cannot be a reason for “Failed to get remote orchestrator interfaces” error message, when clicking on “Orchestrator” in WebUI?

QUESTION 34
How many power supplies are presented on MHO-140?

QUESTION 35
There are two 10Gbps dual-port NIC installed on a 6800 appliance. Which interfaces should be connected to Orchestrator 1 for downlinks’ intra-orchestrator redundancy when using two Orchestrators?

QUESTION 36
What command should be used for collecting diagnostic information about the orchestrator?

QUESTION 37
What cannot be learned from the output of asg perf -v -p command?

QUESTION 38
Which file on Appliance includes information about Security Group?

QUESTION 39
What is the Orchestrator?

QUESTION 40
What command will be used for updating fwkern.conf file on all Appliances within Security Group?

QUESTION 41
What is the default range of physical ports for downlinks on Orchestrator MHO-140?

QUESTION 42
How many power supplies are presented on MHO-170?