2022 200-301 Premium Files Test pdf - Free Dumps Collection [Q209-Q227]

NEW QUESTION 209
Which value is indicated by the next hop in a routing table?

preference of the route source

IP address of the remote router for forwarding the packets

how the route was learned

exit interface IP address for forwarding the packets

NEW QUESTION 210
Which two command sequences must you configure on a switch to establish a Layer 3 EtherChannel with an open-standard protocol? (choose two)

interface GigabitEthernet0/0/1 Channel-group 10 mode active

interface GigabitEthernet0/0/1 Channel-group 10 mode auto

interface GigabitEthernet0/0/1 Channel-group 10 mode on

interface port-channel 10 no switchport ip address 172.16.0.1 255.255.255.0

interface port-channel 10 switchport Switchport mode trunk

NEW QUESTION 211
Refer to the exhibit.

What action establishes the OSPF neighbor relationship without forming an adjacency?

modify hello interval

modify process ID

modify priority

modify network type

NEW QUESTION 212
Refer to the exhibit.

Which Command do you enter so that R1 advertises the loopback0 interface to the BGP Peers?

Network 172.16.1.32 mask 255.255.255.224

Network 172.16.1.0 0.0.0.255

Network 172.16.1.32 255.255.255.224

Network 172.16.1.33 mask 255.255.255.224

Network 172.16.1.32 mask 0.0.0.31

Network 172.16.1.32 0.0.0.31

NEW QUESTION 213
Drag and Drop Question
Drag and drop the networking parameters from the left on to the correct values on the right.

NEW QUESTION 214
Drag and drop the AAA functions from the left onto the correct AAA services on the right

NEW QUESTION 215
Refer to the exhibit. Which feature is enabled by this configuration?

static NAT translation

a DHCP pool

a dynamic NAT address pool

PAT

NEW QUESTION 216
Drag and drop the functions from the left onto the correct network components on the right

NEW QUESTION 217
Drag and drop the characteristics of network architectures from the left onto the type of architecture on the right.

NEW QUESTION 218
Which action is taken by a switch port enabled for PoE power classification override?

When a powered device begins drawing power from a PoE switch port a syslog message is generated

As power usage on a PoE switch port is checked data flow to the connected device is temporarily paused

If a switch determines that a device is using less than the minimum configured power it assumes the device has failed and disconnects

If a monitored port exceeds the maximum administrative value for power, the port is shutdown and err-disabled

NEW QUESTION 219
Drag and drop the IPv4 network subnets from the left onto the correct usable host ranges on the right

NEW QUESTION 220
DRAG DROP
Refer to the exhibit. PC_1 is sending packets to the FTP server. Consider the packets as they leave RouterA interface Fa0/0 towards RouterB.
Drag the correct frame and packet address to their place in the table.

NEW QUESTION 221
Refer to the exhibit.

An engineer is tasked with verifying network configuration parameters on a client workstation to report back to the team lead. Drag and drop the node identifiers from the left onto the network parameters on the right.

NEW QUESTION 222
Drag and drop the attack-mitigation techniques from the left onto the Types of attack that they mitigate on the right.

NEW QUESTION 223
Refer to the exhibit.

Which command provides this output?

show ip route

show ip interface

show interface

show cdp neighbor

NEW QUESTION 224
Refer to the exhibit.

Which configuration enables DHCP addressing for hosts connected to interface FastEthernetO/1 on router R4?